- Fabrication of dye-sensitized solar cells by transplanting highly ordered TiO(2) nanotube arrays
[作者:Park, H; Kim, WR; Jeong, HT; Lee, JJ; Kim, HG; Choi, WY,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:184-189 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- Highly ordered TiO(2) nanotube arrays fabricated by anodization are very attractive to dye-sensitized solar cells (DSCs) due to their superior charge percolation and slower charge recombination. However, the efficiency o...
- Structural and optical properties of textured ZnO:Al films on glass substrates prepared by in-line rf magnetron sputtering
[作者:Cho, JS; Kim, YJ; Lee, JC; Park, SH; Yoon, KH,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:190-194 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- Textured ZnO:Al films with excellent light scattering properties as a front electrode of silicon thin film solar cells were prepared on glass substrates by an in-line rf magnetron sputtering, followed by a wet-etching pr...
- Substrate dependent stability and interplay between optical and electrical properties in mu c-Si: H single junction solar cells
[作者:Boccard, M; Cuony, P; Despeisse, M; Domine, D; Feltrin, A; Wyrsch, N; Ballif, C,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:195-198 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- In this work, we analyze the effect of rough ZnO. front electrodes developed in-house favoring high current versus "smoother" substrates favoring good V(oc) and FF on the properties of microcrystalline silicon (mu c-Si :...
- Material properties of microcrystalline silicon for solar cell application
[作者:Lee, CH; Shin, M; Lim, MH; Seo, JY; Lee, JE; Lee, HY; Kim, BJ; Choi, D,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:207-210 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- The paper reviews the material requirements of microcrystalline silicon (mu c-Si) in terms of the device operation and configuration for thin film solar cells and thin film transistors (TFTs). We investigated the materia...
- Reduction of amorphous incubation layer by HCl addition during deposition of microcrystalline silicon by hot-wire chemical vapor deposition
[作者:Chung, YB; Lee, DK; Lim, JS; Hwang, NM,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:211-214 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- The amorphous incubation layer, which is formed in the initial growth stage of hydrogenated microcrystalline silicon (mu c-Si:H) thin film deposited at low temperature, is harmful to the electric properties of film. In t...
- Cu(In,Ga)Se(2) solar cells with superstrate structure using lift-off process
[作者:Osada, S; Abe, Y; Anegawa, T; Minemoto, T; Takakura, H,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:223-226 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- Cu(In,Ga)Se(2) (CIGS) solar cells with a superstrate structure were fabricated using a lift-off process. To widen the variety of substrate choices for CIGS solar cells, a lift-off process was developed without an intenti...
- Dependence of Se beam pressure on defect states in CIGS-based solar cells
[作者:Sakurai, T; Islam, MM; Uehigashi, H; Ishizuka, S; Yamada, A; Matsubara, K; Niki, S; Akimoto, K,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:227-230 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- The influence of Se beam pressure on defect properties in Cu(In(1-x),Ga(x))Se(2) (CIGS)-based solar cells fabricated by the three-stage process was investigated by admittance spectroscopy. The Se beam pressure was varied...
- Determination of Cu(In(1-x)Ga(x))(3)Se(5) defect phase in MBE grown Cu(In(1-x)Ga(x))Se(2) thin film by Rietveld analysis
[作者:Islam, MM; Sakurai, T; Yamada, A; Otagiri, S; Ishizuka, S; Matsubara, K; Niki, S; Akimoto, K,期刊:SOLAR ENERGY MATERIALS AND SOLAR CELLS, 页码:231-234 , 文章类型: Article; Proceedings Paper,,卷期:2011年95-1]
- Quantitative phase analysis of Cu(In(1-x)Ga(x))Se(2) (CIGS) thin film grown over Mo coated soda lime glass substrates was studied by Rietveld refinement process using room temperature X-ray data at theta-20 mode. Films w...
|