- Design and calibration of a MEMS sensor for measuring the force and torque acting on a magnetic microrobot - art. no. 025004
[作者:Beyeler, F; Muntwyler, S; Nagy, Z; Graetzel, C; Moser, M; Nelson, BJ,期刊:Journal of Micromechanics and Microengineering, 页码:25004-25004 , 文章类型: Article,,卷期:2008年18-2]
- This paper presents the design, fabrication and calibration of a multi-axis micro force-torque sensor. The sensor and its readout electronics are specifically designed to simultaneously measure two force components and o...
- Modelling and experimental analysis of the effects of tool wear, minimum chip thickness and micro tool geometry on the surface roughness in micro-end-milling - art. no. 025006
[作者:Li, HT; Lai, XM; Li, CF; Feng, J; Ni, J,期刊:Journal of Micromechanics and Microengineering, 页码:25006-25006 , 文章类型: Article,,卷期:2008年18-2]
- Tool wear, minimum chip thickness and micro tool geometry are found to have a significant influence on the surface roughness through experimental analysis of the micro-end-milling process. To address these issues, a surf...
- Electrical discharge machining of carbon nanomaterials in air: machining characteristics and the advanced field emission applications - art. no. 025007
[作者:Ok, JG; Kim, BH; Chung, DK; Sung, WY; Lee, SM; Lee, S; Kim, WJ; Park, J; Chu, CN; Kim, YH,期刊:Journal of Micromechanics and Microengineering, 页码:25007-25007 , 文章类型: Article,,卷期:2008年18-2]
- A reliable and precise machining process, electrical discharge machining (EDM), was investigated in depth as a novel method for the engineering of carbon nanomaterials. The machining characteristics of EDM applied to car...
- A two axes scanning SOI MEMS micromirror for endoscopic bioimaging - art. no. 025001
[作者:Singh, J; Teo, JHS; Xu, Y; Premachandran, CS; Chen, N; Kotlanka, R; Olivo, M; Sheppard, CJR,期刊:Journal of Micromechanics and Microengineering, 页码:25001-25001 , 文章类型: Article,,卷期:2008年18-2]
- A novel silicon on insulator (SOI) MEMS process has been designed and developed to realize a two axes thermally actuated single crystal silicon micromirror device, which consists of a mirror plate, four flexural springs ...
- CO2-assisted embossing for the fabrication of PMMA components under low temperature and with low pressure - art. no. 025024
[作者:Yang, SY; Huang, TC; Ciou, JK; Chan, BD; Loeser, JG,期刊:Journal of Micromechanics and Microengineering, 页码:25024-25024 , 文章类型: Article,,卷期:2008年18-2]
- Gas-assisted pressurizing has been proven to provide a uniform pressure distribution over a large-area substrate. This paper reports an innovative embossing technique, which makes use of the unique combination of plastic...
|